Table of Contents


gluPerspective - set up a perspective projection matrix

C Specification

void gluPerspective( GLdouble fovy,
    GLdouble aspect,
    GLdouble zNear,
    GLdouble zFar )

eqn not supported


Specifies the field of view angle, in degrees, in the y direction.
Specifies the aspect ratio that determines the field of view in the x direction. The aspect ratio is the ratio of x (width) to y (height).
Specifies the distance from the viewer to the near clipping plane (always positive).
Specifies the distance from the viewer to the far clipping plane (always positive).


gluPerspective specifies a viewing frustum into the world coordinate system. In general, the aspect ratio in gluPerspective should match the aspect ratio of the associated viewport. For example, $ "aspect" ~=~ 2.0 $ means the viewer's angle of view is twice as wide in x as it is in y. If the viewport is twice as wide as it is tall, it displays the image without distortion.

The matrix generated by gluPerspective is multipled by the current matrix, just as if glMultMatrix were called with the generated matrix. To load the perspective matrix onto the current matrix stack instead, precede the call to gluPerspective with a call to glLoadIdentity.

Given f defined as follows:

eqn not supported The generated matrix is

eqn not supported


Depth buffer precision is affected by the values specified for zNear and zFar. The greater the ratio of zFar to zNear is, the less effective the depth buffer will be at distinguishing between surfaces that are near each other. If

$r ~=~ "zFar" over "zNear"$

roughly $log sub 2 r$ bits of depth buffer precision are lost. Because $r$ approaches infinity as zNear approaches 0, zNear must never be set to 0.

See Also

glFrustum(3G) , glLoadIdentity(3G) , glMultMatrix(3G) , gluOrtho2D(3G)

Table of Contents